Sunday, September 14, 2014
Bedside Lamp Timer
The purpose of this schema is to power a lamp or other appliance for a given time (30 minutes in this case), and then to turn it off. It is useful when reading at bed by night, turning off the bedside lamp automatically in case the reader falls asleep... After turn-on by P1 pushbutton, the LED illuminates for around 25 minutes, but then it starts to blink for two minutes, stops blinking for two minutes and blinks for another two just before switching the lamp off, thus signaling that the on-time is ending. If the user want to prolong the reading, he/she can earn another half-hour of light by pushing on P1. Turning-off the lamp at users ease is obtained by pushing on P2
Parts:
R1________1K 1/4W Resistor R2________4K7 1/4W Resistor R3_______10M 1/4W Resistor R4________1M 1/4W Resistor R5_______10K 1/4W Resistor C1_______470µF 25V Electrolytic Capacitor C2-C4____100nF 63V Polyester Capacitors D1-D4____1N4002 100V 1A Diodes D5_______5mm. Red LED IC1______4012 Dual 4 input NAND gate IC IC2______4060 14 stage ripple counter and oscillator IC Q1_______BC328 25V 800mA PNP Transistor Q2_______BC547 45V 100mA NPN Transistor P1,P2____SPST Pushbuttons T1_______220V Primary, 9 + 9V Secondary 1VA Mains transformer RL1______10.5V 470 Ohm Relay with SPDT 2A 220V switch PL1______Male Mains plug SK1______Female Mains socket Q1 and Q2 form an ALL-ON ALL-OFF schema that in the off state draws no significant current. P1 starts the schema, the relay is turned on and the two ICs are powered. The lamp is powered by the relay switch, and IC2 is reset with a positive voltage at pin 12. IC2 starts oscillating at a frequency set by R4 and C4. With the values shown, pin 3 goes high after around 30 minutes, turning off the schema via C3. During the c6 minutes preceding turn-off, the LED does a blinking action by connections of IC1 to pins 1, 2 & 15 of IC2. Blinking frequency is provided by IC2 oscillator at pin 9. The two gates of IC1 are wired in parallel to source more current. If required, a piezo sounder can be connected to pins 1 & 14 of IC1. Obviously, timings can be varied changing C4 and/or R4 values.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment