Showing posts with label transmitter. Show all posts
Showing posts with label transmitter. Show all posts

Tuesday, October 28, 2014

Circuit diagram BA1404 based Stereo transmitter

Using BA1404 can be designed a very simple and useful stereo fm stereo modulator electronic project . This BA1404 fm stereo modulator device works in FM broadcast band ( 75- 108MHz) and require few external common components .
The BA1404 fm stereo modulator Ic contains all parts needed to design an simple high efficiency stereo transmitter circuit , it contains a stereo modulator that creates stereo composites signals ,an FM modulator that creates FM signals and a RF amplifier .

The fm stereo transmitter develops composite signals made up of a main(L+R) signal and sub(L-R) signal and a pilot (19KHz) signal using a 38KHz crystal oscillators.
The RF amplifier transmits the stereo encoded signals and is also a buffer for FM modulator .
For this FM stereo transmitter circuit you’ll need a DC power supply that can provide an output voltage between 1.5 an 3 volts . This fm stereo transmitter circuit project can be used for FM stereo transmitters or wireless microphone circuits .
The L1 coil must have 3 turns of 0.5mm wire on a 5 mm core .
Antenna used in this transmitter can be an common telescopic antenna or a 60-80 mm long Cu wire .
Read More..

Saturday, September 20, 2014

Simple UHF Video Transmitter circuit and explanation


Heres video transmitter circuit is working on the UHF channel frequency 470-580 MHz channel 21-34. This video transmitter can radiate as far as 30-100 meters by using a cable 10-20 cm. If you have a plan to amplify this video transmitters signal, please make a good bandpass filter.


This video transmitter requires supplies voltage of 9-15 volt. However, you can also use a 9v batteries. Better result on low signal noise, use switching power supply.


This is an important thing to remember for building of the video transmitter circuit is that the dimensions of coil size to match the frequency of the desired work. The value of the spindle is making coil as follows:
L1, L2 = 3 Turns, diam. 3mm, 0.5mm wire
L3 = 2 Turns, diam. 3 mm, 0.5 mm wire
Read More..

Friday, August 8, 2014

Coilless FM transmitter



The RF oscillator using the inverter N2 and 10.7Mhz ceramic filter is driving the parallel combination of N4 to N6 through N3.Since these inverters are in parallel the output impedance will be low so that it can directly drive an aerial of 1/4th wavelength. Since the output of N4-N6 is square wave there will be a lot of harmonics in it. The 9th harmonics of 10.7Mhz (96.3Mhz) will hence be at the center of the FM band .
N1 is working as an audio amplifier. The audio signals from the microphone are amplified and fed to the varycap diode. The signal varies the capacitance of the varycap and hence varies the oscillator frequency which produce Frequency Modulation.



http://www.electronic-diagram-diagrams.com/radioimages/8.gif
Read More..